Pressurestat MATER 1/8 BSP

Pressurestat MATER XP-110

15A 250 V 1/8 BSP fitting

0,5-1,5bar

Pre-calibrated at 1.1 bar (due to the pre-calibration, not only will they show a dab of paint on the screw but also the fitting will show residues of thread sealant which is not a sign of a “used” component).

NOTE 1: This is not a common size and and it is installed only on few espresso machines (i.e. some versions of a Le-Lit Mara) versus the standard 1/4 BSP version.

Since it is a non returnable item, check the fitting size if your existing pressurestat before ordering, which should be approximately 9.8mm.

NOTE 2: Copper Pipe must be clean and descaled prior to installation. Failure to do so could damage the component.